Juniper T1600 Hardware Manual page 306

T1600 Core Router Hardware Guide
282
Disconnect the wires from the AC terminal block on the three-phase delta AC power
9.
supply (Figure 165 on page 282), Use a 1/4-in. slotted screwdriver to loosen each of the
input terminals or grounding point screws, and remove each wire from the grounding
point or input terminal.
Remove the wire labeled
a.
Remove the wire labeled
b.
Remove the wire labeled
c.
Remove the wire labeled
d.
Figure 165: Disconnecting the Power Cord from a Three-Phase Delta AC
Power Supply
L1 L2 L3
Loosen the plastic cable tie fastening the AC power cord to the power supply.
10.
Loosen and remove the retaining nut from the AC power cord.
11.
Pull the AC power cord out of the metal wiring compartment.
12.
Carefully move the AC power cable out of the way.
13.
Disconnect the AC power cord from the AC power supply.
14.
Loosen the captive screws on the lower corners of the power supply faceplate
15.
completely.
Twist the ejector handles on the upper corners of the faceplate counterclockwise to
16.
unseat the power supply.
L3 from the L3 input terminal.
from the input terminal.
L2 L2
L1 from the L1 input terminal.
from the grounding point labeled
GND
L1 L2 L3
Copyright © 2010, Juniper Networks, Inc.
.
GND