Installing A T1600 Three-Phase Delta Ac Power Supply Cord - Juniper T1600 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.

Installing a T1600 Three-Phase Delta AC Power Supply Cord

To install a three-phase delta AC power supply cord:
Make sure that the voltage across the AC power source cord leads is 0 V and that
1.
there is no chance that the cord might become active during installation.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the power switch on the power supply faceplate to the standby position.
3.
Using a number 2 Phillips (+) screwdriver, loosen the two screws on the door of the
4.
metal wiring compartment that protects the AC terminal block.
Open the door of the metal wiring compartment.
5.
Unscrew the retaining nut from the AC power cord.
6.
Place the retaining nut inside the metal wiring compartment.
7.
Put the wires of the AC power cord through the hole of the metal wiring compartment.
8.
Screw the retaining nut onto the AC power cord to secure it to the metal wiring
9.
compartment.
Chapter 17: Replacing T1600 Router Hardware Components
289