Verifying The Installation Of A T1600-Sib - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Verifying the Installation of a T1600-SIB

Related
Documentation
232
Figure 133: Installing a T1600-SIB in a T1600
To verify that the T1600-SIB is functioning normally:
Check the LEDs on the T1600-SIB faceplate.
1.
The green OK LED should light steadily a few minutes after the T1600-SIB is installed.
If the LED is lit steadily, remove and install the T1600-SIB again. Make sure
FAIL
that the T1600-SIB is seated properly. If the
T1600-SIB is not functioning properly. Contact your customer support representative.
Verify that four T1600-SIBs are in the
2.
Display the status of the T1600-SIB by issuing the
user@host> show chassis sibs
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online
To bring a T1600-SIB online, issue the
command.
T1600 Preventing Electrostatic Discharge Damage on page 312
Maintaining the T1600 SIBs on page 168
T1600 Switch Interface Board (SIB) Description on page 32
FAIL LED still lights steadily, the
state and one SIB is in the
Online
show chassis sibs
Uptime
0 days, 30 minutes, 12 seconds
0 days, 25 minutes, 45 seconds
0 days, 20 minutes, 28 seconds
0 days, 15 minutes, 7 seconds
0 days, 10 minutes, 52 seconds
request chassis sib online
Copyright © 2010, Juniper Networks, Inc.
state.
Spare
command:
operational mode