Juniper T1600 Hardware Manual page 259

Copyright © 2010, Juniper Networks, Inc.
slots. You might have to close and open the handles a few times before the tabs catch
the slots.
Tighten the captive screws on the ejector handles.
6.
Remove the dust cover from covering each TXP-F13 SIB fiber-optic array port.
7.
Remove the dust covers from the fiber-optic array cable connectors.
8.
Clean the fiber-optic array ports and cables.
9.
CAUTION: While you replace a fiber-optic array cable, small deposits of
oil, dust, and debris can enter the TXP-F13 SIB and TXP-T1600 SIB
fiber-optic array ports, the fiber-optic array cables. We recommend that
you clean the optics in these components, as well as the dust covers,
immediately before connecting them.
Connect each cable to its corresponding TXP-T1600 port. Align the cable with its
10.
corresponding TXP-T1600 SIB port and carefully press it into the port until it stops.
The cable and port are keyed to ensure proper mating.
NOTE: The optics in a fiber-optic array port are spring loaded, so you must
continue to apply force to a fiber-optic array cable or loopback connector
while securing it to a TXP-T1600 SIB.
Bring the TXP-T1600 SIB online using one of the following methods:
11.
Press and hold the
ONLINE/OFFLINE
green OK LED on the faceplate begins to blink. Hold the button down until the LED
blinks.
Issue the following CLI command on the router:
user@host> request chassis sib online slot 0
Chapter 17: Replacing T1600 Router Hardware Components
button on the TXP-T1600 SIB faceplate. The
235