Installing The T1600 Front Air Filter - Juniper T1600 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
cable management system and tray, and secure them with temporary fasteners so
that they are not supporting their own weight as they hang from the connector.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Simultaneously pull the two releases on the cable management system. Lift it up and
3.
outward to lock it in place to access the air filter.
Loosen the captive screws on the corners of the air filter faceplate.
4.
Grasp the handles and pull the air filter straight out of the chassis.
5.
Remove the filter element from the air filter frame (see Figure 111 on page 207).
6.
Figure 110: Removing the Front Air Filter
Figure 111: Replacing the Front Filter Element

Installing the T1600 Front Air Filter

To install the front air filter (see Figure 112 on page 208):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Insert the filter element into the air filter frame.
2.
Grasp the air filter by the handles on its faceplate, and slide it straight into the chassis.
3.
Tighten the captive screws on the corners of the faceplate.
4.
Chapter 17: Replacing T1600 Router Hardware Components
207