Attaching The T1600 Installation Handle - Juniper T1600 Hardware Manual

Attaching the T1600 Installation Handle

Copyright © 2010, Juniper Networks, Inc.
Place one hand underneath the power supply to support it and slide it completely out
6.
of the chassis.
Repeat the procedure for the other power supply.
7.
Figure 56: Removing a Three-Input 240-A DC Power Supply
To assist you with the installation of the router, attach the installation handle over the
power supply slots of the chassis. To attach the installation handle:
Place the installation handle over the location of the lower power supply.
1.
Tighten the captive screws of the handle into the holes previously occupied by the
2.
captive screws of the power supply (see Figure 57 on page 97).
Figure 57: Attaching the Installation Handle
Chapter 9: Installing the T1600 Router Using a Mechanical Lift
97