Installing The Mx960 Craft Interface - Juniper MX960 Hardware Manual

Installing the MX960 Craft Interface

To install the craft interface (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Grasp the craft interface with one hand, and hold the bottom edge of the craft interface with the other
hand to support its weight.
3. Orient the ribbon cable so that it plugs into the connector socket. The connector is keyed and can be
inserted only one way.
4. Align the bottom of the craft interface with the sheet metal above the card cage and press it into place.
5. Tighten the screws on the left and right corners of the craft interface faceplate.
6. Reattach any external devices connected to the craft interface.
Figure 133: Installing the Craft Interface
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX960 Router
Disconnecting the Alarm Relay Wires from the MX960 Craft Interface | 433
Removing the MX960 Craft Interface | 434
Figure 101 on page 315):
382