T1600 Line-Card Chassis Control Board (Lcc-Cb) Description; T1600 Lcc-Cb Leds - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
Related
Documentation
48

T1600 Line-Card Chassis Control Board (LCC-CB) Description

The LCC-CBs (see Figure 29 on page 48) must be installed before you can connect a
T1600 router to a TX Matrix Plus Router.
Each LCC-CB consists of the following components:
100-MB Ethernet switch for intermodule communication.
PCI bus to the Routing Engines.
Switch processor mezzanine board (SPMB).
The following components are located on the LCC-CB faceplate:
Two configuration switches: the must be set to
must always be set to
S
The M/S configuration switch must be set to
a TX Matrix Plus Router.
The configuration switch is set to
CHASSIS ID
for the T1600 router.
Three LEDs labeled MASTER
The online/offline button.
Six RJ-45 ports labeled
router. Two LEDs labeled
are not currently supported.
One JCS port, which is not used. The
supported.
Figure 29: LCC-CB on the T1600 Router
T1600 Host Subsystem Description on page 36
T1600 Control Boards Description on page 45
T1600 LCC-CB LEDs on page 48

T1600 LCC-CB LEDs

Status LEDs and port LEDs are located on the faceplate of the LCC-CB (see Figure 30
on page 49).
CHASSIS ID
and .
0
M before you connect the LCC-CB to
through
0
, FAIL , and OK indicate its status.
through .
SFC0 SFC4 SFC0
LINK and ACT indicate the status of
LED for this port is also not currently
LINK
configuration switches
to indicate the LCC number
4
connects to the TX Matrix Plus
SFC0 . SFC1 through
Copyright © 2010, Juniper Networks, Inc.
SFC4