Installing A T1600 T-Cb; Replacing A T1600 Lcc-Cb - Juniper T1600 Hardware Manual

Replacing a T1600 LCC-CB

Copyright © 2010, Juniper Networks, Inc.

Installing a T1600 T-CB

To install a T-CB (see Figure 119 on page 217):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the T-CB with the guides inside the chassis.
2.
Slide the T-CB into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles, and press them inward to seat the T-CB.
4.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
5.
number 2.
If power is applied to the Routing Engine and its corresponding T-CB is functioning
6.
normally, the T-CB comes online automatically. To verify that the T-CB is functioning
normally, check the LEDs on its faceplate. The green
few minutes after the T-CB is installed. If the
the T-CB again. If the
FAIL
Contact your customer support representative.
To check the status of the T-CB, use the CLI command:
user@host> show chassis environment cb
Figure 119: Installing a T-CB
Removing a T1600 LCC-CB on page 218
1.
Installing a T1600 LCC-CB on page 219
2.
Chapter 17: Replacing T1600 Router Hardware Components
FAIL LED is lit steadily, remove and install
LED still lights steadily, the T-CB is not functioning properly.
LED should light steadily a
OK
217