Copyright © 2010, Juniper Networks, Inc.
Figure 128: Removing a PC Card
Installing the T1600 PC Card
To install a PC Card (see Figure 129 on page 228):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "T1600 Preventing Electrostatic Discharge Damage" on page 312.
If the Routing Engine cover is in place, remove the cover by loosening the captive
2.
screws on the corners of its faceplate.
Insert the PC Card into the PC Card slot on the Routing Engine, with the Juniper
3.
Networks logo facing downward.
CAUTION: Be sure to insert the PC Card with the label facing downward.
Inserting the PC Card incorrectly might damage the Routing Engine.
NOTE: The Routing Engine 1600 has two PC Card slots. In this case, use
either slot. Do not install more than one PC Card in the Routing Engine.
Press the card firmly all the way into the slot.
4.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
5.
to secure it to the chassis.
Chapter 17: Replacing T1600 Router Hardware Components
227