Reinstalling The T1600 Sibs - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Reinstalling the T1600 SIBs

118
Figure 75: Reinstalling a T-CB
Figure 76: Reinstalling an LCC-CB
To reinstall the SIBs (see Figure 77 on page 119):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the SIB.
5.
Copyright © 2010, Juniper Networks, Inc.