T1600 Routing Engine Interface Cable And Wire Specifications - Juniper T1600 Hardware Manual

Related
Documentation

T1600 Routing Engine Interface Cable and Wire Specifications

Copyright © 2010, Juniper Networks, Inc.
P = P – LL
M B
P = 13 dB – 2 km (1.0 dB/km) – 5 (0.5 dB) – 2 (0.5 dB) – 0.5 dB [HOL] – 1 dB [CRM]
M
P = 13 dB – 2 dB – 2.5 dB – 1 dB – 0.5 dB – 1 dB
M
P = 6 dB
M
The following sample calculation for an 8 km-long single-mode link with an optical power
budget ( P ) of 13 dB uses the estimated values from Table 55 on page 368 to calculate
B
link loss ( ) as the sum of fiber attenuation (8 km @ 0.5 dB/km, or 4 dB) and loss for
LL
seven connectors (0.5 dB per connector, or 3.5 dB). The optical power margin (
calculated as follows:
P = P – LL
M B
P = 13 dB – 8 km (0.5 dB/km) – 7 (0.5 dB)
M
P = 13 dB – 4 dB – 3.5 dB
M
P = 5.5 dB
M
In both examples, the calculated optical power margin is greater than zero, indicating
that the link has sufficient optical power for transmission and does not exceed the
maximum receiver input power.
T1600 Calculating Optical Power Budget for Fiber-Optic Cable on page 367
Table 56 on page 369 lists the specifications for the cables that connect to management
ports and the wires that connect to the alarm relay contacts.
Table 56: Cable and Wire Specifications for Routing Engine Management
and Alarm Interfaces
Port Cable Specification
Routing Engine RS-232 (EIA-232) serial
console or cable
auxiliary
interface
Routing Engine Category 5 cable or
Ethernet equivalent suitable for
interface 100Base-T operation
Alarm relay Wire with gauge
contacts between 28-AWG and
14-AWG (0.08 and 2.08
2
mm )
Appendix E: T1600 Router Cable and Wire Guidelines and Specifications
Cable/Wire
Supplied
One 6-ft (1.83-m)
length with
DB-9/DB-9
connectors
One 15-ft (4.57-m)
length with
RJ-45/RJ-45
connectors
NO
P ) is
M
Maximum Router
Length Receptacle
6 ft DB-9 male
(1.83 m)
328 ft RJ-45
(100 m) autosensing
None —
369