Installing A T1600 Fpc - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
240
Figure 136: Removing an FPC

Installing a T1600 FPC

CAUTION: The FPC power connector is located in the corner where the bottom
and the connector edges meet. If a power connector prong becomes bent, it
no longer aligns with the female connector on the midplane, and the FPC no
longer functions.
To install an FPC (see Figure 138 on page 244 and Figure 139 on page 245):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "T1600 Preventing Electrostatic Discharge Damage" on page 312.
Place the FPC on an antistatic mat.
2.
Take each PIC to be installed in the replacement FPC out of its electrostatic bag and
3.
identify the slot on the FPC where it will be connected.
Copyright © 2010, Juniper Networks, Inc.