Installing A T1600-Sib - Juniper T1600 Hardware Manual

Installing a T1600-SIB

Copyright © 2010, Juniper Networks, Inc.
Figure 132: Removing a T1600-SIB
Each T1600-SIB weighs approximately 6.5 lb (3 kg). To install a T1600-SIB (see Figure
133 on page 232):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the T1600-SIB to support it. With the other hand, hold
2.
one of the ejector handles on the T1600-SIB faceplate.
Carefully align the sides of the T1600-SIB with the guides inside the chassis.
3.
Slide the T1600-SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the T1600-SIB. Ensure that
5.
the ejector handle tabs are properly mated inside their corresponding chassis slots.
You might have to close and open the handles a few times before the tabs catch the
slots.
Tighten the captive screws on the ejector handles.
6.
Bring the T1600-SIB online using one of the following methods:
7.
Press and hold the ONLINE/OFFLINE
LED on the faceplate begins to blink. Hold the button down until the LED blinks.
OK
Issue the following CLI command on the router:
user@host> request chassis sib online slot 0
Chapter 17: Replacing T1600 Router Hardware Components
button on the T1600-SIB faceplate. The green
231