Juniper T1600 Hardware Manual page 267

Copyright © 2010, Juniper Networks, Inc.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Insert the appropriate cable into the cable connector ports on each PIC on the FPC.
18.
Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop, using the cable management system. Placing
fasteners on a loop helps to maintain its shape.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the FPC online:
19.
Press and hold the FPC online/offline button until the green
button lights steadily, in about 5 seconds. The LEDs and online/offline button for
each FPC are located directly above it on the craft interface.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
CAUTION: After the
removing the FPC again, removing an FPC from a different slot, or inserting
an FPC in a different slot.
You can also verify correct FPC and PIC functioning by issuing the
show chassis fpc pic-status
page 156 and "Maintaining T1600 PICs and PIC Cables" on page 166.
Chapter 17: Replacing T1600 Router Hardware Components
OK LED lights steadily, wait at least 30 seconds before
commands, as described in "Maintaining T1600 FPCs" on
LED next to the
OK
show chassis fpc and
243