Installing A T1600 Dc Power Supply Cable - Juniper T1600 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
Figure 161: Disconnecting a Power Cable from a Four-Input 240-A DC
Power Supply
Cable lug
Locking
washer
Nut
Remove the cable lug from the terminal stud on the power supply.
8.
Loosen the captive screw or screws on the cable restraint on the right edge of the
9.
power supply faceplate.
Carefully move the power cable out of the way.
10.

Installing a T1600 DC Power Supply Cable

You can use this procedure to install a DC power cable on either a three-input 240-A DC
power supply or a four-input 240-A DC power supply. To install a DC power supply cable:
Locate a DC power cable that meets the specifications defined in "T1600 DC Power
1.
Cables and Lugs" on page 354.
CAUTION: A licensed electrician must attach a cable lug to the power
cable that you supply. A cable with an incorrectly attached lug can damage
the router.
Route the power cable through the cable restraint.
2.
Attach the lug on the DC source power cable to the terminal stud.
3.
Attach a positive (+) DC source power cable lug to the
a.
Chapter 17: Replacing T1600 Router Hardware Components
Terminal studs
(return) terminals.
RETURN
277