Copyright © 2010, Juniper Networks, Inc.
Figure 140: Removing a PIC
Installing a T1600 PIC
To install a PIC (see Figure 141 on page 249):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION: Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
Chapter 17: Replacing T1600 Router Hardware Components
247