Removing A T1600 Three-Input 240-A Power Supply - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
260

Removing a T1600 Three-Input 240-A Power Supply

To remove a three-input 240-A DC power supply:
Switch off the external circuit breakers to the power supply being removed. Make sure
1.
that the voltage across the DC power source cable leads is 0 V and that there is no
chance that the cables might become active during the removal process.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on the power supply faceplate to the off position (
3.
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
Remove the clear plastic cover protecting the terminal studs on the faceplate.
4.
Using a 7/16-in. (11 mm) nut driver or wrench, remove the nuts and washers from the
5.
terminal studs (see Figure 146 on page 261).
CAUTION: You must ensure that power connections maintain the proper
polarity. The power source cables might be labeled
their polarity. There is no standard color coding for DC power cables. The
color coding used by the external DC power source at your site determines
the color coding for the leads on the power cables that attach to the
terminal studs on each power supply.
O
(+) and (–) to indicate
Copyright © 2010, Juniper Networks, Inc.
).