Juniper T1600 Hardware Manual page 285

Copyright © 2010, Juniper Networks, Inc.
Figure 146: Disconnecting Power Cables from the DC Power Supply
Remove the cable lugs from the terminal studs.
6.
Loosen the captive screw or screws on the cable restraint on the right edge of the
7.
power supply faceplate.
Carefully move the power cables out of the way.
8.
Loosen the captive screws on the lower corners of the power supply faceplate
9.
completely.
Twist the ejector handles on the upper corners of the faceplate counterclockwise to
10.
unseat the power supply.
Grasp the handle on the power supply faceplate and pull firmly. Slide it halfway out
11.
of the chassis (see Figure 148 on page 262).
CAUTION: Each three-input 240-A DC power supply weighs approximately
25 lb (11.3 kg). Be prepared to support the full weight of the power supply
as you remove it from the router.
Place one hand underneath the power supply to support it, and slide it completely
12.
out of the chassis.
Chapter 17: Replacing T1600 Router Hardware Components
261