Reinstalling the T1600 SCGs
Reinstalling the T1600 Control Boards
Copyright © 2010, Juniper Networks, Inc.
To reinstall the SCGs (see Figure 74 on page 117):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Carefully align the sides of the SCG with the guides in the SCG slot.
2.
Grasp the SCG by its handle and slide it straight into the chassis until it contacts the
3.
midplane.
Tighten the captive screws on the corners of the SCG faceplate.
4.
Repeat the procedure to reinstall the remaining SCG.
5.
Figure 74: Reinstalling an SCG
To reinstall the control boards (see Figure 75 on page 118 and Figure 76 on page 118):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Carefully align the sides of the control boards with the guides inside the chassis.
2.
Slide the control boards into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles and press them inward to seat the control board.
4.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
5.
number 2.
Repeat the procedure to reinstall the remaining control board.
6.
Chapter 10: Installing the T1600 Router Without a Mechanical Lift
117