Removing The T1600 Standard Rear Fan Tray - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Removing the T1600 Standard Rear Fan Tray

108
Figure 67: Removing an SCG
The rear fan tray is mounted vertically on the right side of the rear of the chassis. The
standard rear fan tray contains eight fans. The standard fan tray weighs about
10 lb (4.5 kg).
To remove the standard rear fan tray (see Figure 68 on page 109):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the top and bottom of the fan tray faceplate.
2.
Grasp the handles and pull the fan tray halfway out of the chassis.
3.
Place one hand under the fan tray to support it and pull the fan tray completely out
4.
of the chassis.
Copyright © 2010, Juniper Networks, Inc.