Installing A T320 Craft Interface; Figure 71: Removing A T320 Craft Interface; Figure 72: Installing A Replacement T320 Craft Interface - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide
See Also

Installing a T320 Craft Interface

See Also
190

Figure 71: Removing a T320 Craft Interface

Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Craft Interface Description on page 20
T320 Craft Interface LCD and Navigation Buttons on page 22
To install the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasping the craft interface by the top and bottom edges, press it into place.
2.
Tighten the screws at the corners of the craft interface.
3.
NOTE: When you install the craft interface in an operating router, allow
several minutes for the LEDs on the craft interface to reflect the current
state of the router.

Figure 72: Installing a Replacement T320 Craft Interface

Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 Craft Interface Description on page 20
T320 Craft Interface LCD and Navigation Buttons on page 22
Figure 72 on page 190):
Copyright © 2018, Juniper Networks, Inc.