Reinstalling The T1600 Ac Power Supplies - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
120
Figure 78: Reinstalling a Three-Input 240-A DC Power Supply
Figure 79: Reinstalling a T1600 Four-Input 240-A DC Power Supply

Reinstalling the T1600 AC Power Supplies

You can use this procedure to reinstall either the three-phase delta or wye AC power
supplies. Reinstall the lower power supply first, then the upper power supply. To reinstall
the AC power supplies (see Figure 78 on page 120):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Switch the power switch on the power supply faceplate to the standby position.
2.
Using both hands, slide the power supply into the chassis until you feel resistance.
3.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
4.
until they stop.
Tighten the captive screws at the lower corners of the power supply faceplate to
5.
secure the power supply in the chassis.
Repeat the procedure for the upper power supply.
6.
Copyright © 2010, Juniper Networks, Inc.