Juniper T1600 Hardware Manual page 328

T1600 Core Router Hardware Guide
Related
Documentation
304
Switch the power switch on the power supply to the
12.
Verify that the LED on the power supply faceplate is lit steadily, indicating that
DC OK
13.
the power supply is correctly installed and is functioning properly. The
blinks momentarily, then lights steadily.
NOTE: After a power supply is powered on, it can take up to 60 seconds
for status indicators—such as the LEDs on the power supply, the command
output displays, and messages on the LED display on the craft interface—to
indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.
Figure 184: Installing the Side Power Supply Filter
Air filter bracket
T1600 Three-Phase Delta and Wye AC Power Supply Overview on page 65
Maintaining the T1600 Power Supplies on page 169
T1600 Preventing Electrostatic Discharge Damage on page 312
General Safety Guidelines for M Series, MX Series, and T Series Routers on page 309
T1600 AC Power Electrical Safety Guidelines on page 339
ON
Air filter
Copyright © 2010, Juniper Networks, Inc.
position ( ).
|
DC OK LED