Tools And Parts Required For Replacing T1600 Hardware Components - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
Related
Documentation

Tools and Parts Required for Replacing T1600 Hardware Components

190
Table 39: Field-Replaceable Units
Hot-Removable and Hot-Insertable FRUs
Air filters
Flexible PIC Concentrators (FPCs)
Front and rear fan trays
PICs
Redundant power supplies
Master SONET Clock Generators (SCG)
Switch Interface Boards (T1600-SIBs or
TXP-T1600 SIBs)
Backup control board (T-CB or LCC-CB)
Master control board (T-CB or LCC-CB) (if
nonstop active routing is configured)
Backup Routing Engine
Master Routing Engine (if nonstop active routing
is configured)
Taking the T1600 Host Subsystem Offline on page 213
T1600 System Architecture Description on page 7
T1600 Chassis Description on page 14
To replace hardware components, you need the tools and parts listed in Table 40 on
page 190.
Table 40: Tools and Parts Required for Component Replacement
Components
All
AC power supply
Three-phase delta AC power supply or
three-phase wye AC power supply
Air filter (front or rear)
CIP
Hot-Pluggable FRUs
Connector Interface Panel (CIP)
Nonredundant control boards (T-CB and
LCC-CB)
Master control board (T-CB or LCC-CB) (if
nonstop active routing is not configured)
Nonredundant Routing Engine
Master Routing Engine (if nonstop active routing
is not configured)
Master SONET Clock Generator (SCG)
Nonredundant SONET Clock Generator (SCG)
Tool or part
Electrostatic discharge (ESD) grounding wrist
strap
Phillips (+) screwdrivers, number 2 to access
the metal AC wiring compartment
1/4-in. slotted screwdriver to attach the ground
wire and input terminal wires of the AC power
cord.
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Copyright © 2010, Juniper Networks, Inc.