Juniper T1600 Hardware Manual page 278

T1600 Core Router Hardware Guide
254
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Pull the ejector handle away from the SFP faceplate to unseat the SFP from the PIC.
6.
Pull the SFP out of the PIC and place it on the antistatic mat or in the electrostatic
bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
Installing a T1600 SFP
To install a replacement SFP:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that a rubber safety cap covers the SFP transceiver, installing one if necessary.
2.
Orient the SFP over the port in the PIC so that the connector end will enter the slot
3.
first and the SFP connector faces the appropriate direction:
If the PIC has ten SFP ports, the ports are arranged in two columns. The SFP
connector faces to the right for ports in the left column, and to the left for ports in
the right column.
If the PIC has one or two SFP ports, the SFP connector faces to the left.
Slide the SFP into the slot. If there is resistance, remove the SFP and flip it so that the
4.
connector faces the other direction.
Remove the rubber safety cap from the transceiver and the end of the cable, and
5.
insert the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Arrange the cable in the cable management system to prevent the cable from
6.
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
Copyright © 2010, Juniper Networks, Inc.