Juniper T1600 Hardware Manual page 165

Copyright © 2010, Juniper Networks, Inc.
Connect the wires to the AC terminal block on the three-phase wye AC power supply
11.
(Figure 89 on page 141). Use a 1/4-in. slotted screwdriver to unscrew each of the input
terminals or grounding point, insert each wire into the grounding point or input terminal,
and tighten the screw.
Insert the wire labeled
a.
Insert the wire labeled
b.
Insert the wire labeled
c.
Insert the wire labeled
d.
Insert the wire labeled
e.
Figure 89: Connecting Power to the Three–Phase Wye AC Power Supply
Verify that the power cable connections are correct.
12.
Using a number 2 Phillips (+) screwdriver, tighten the two captive screws on the metal
13.
AC wiring compartment.
Use the provided plastic cable tie to fasten the AC power cord to the power supply.
14.
Figure 90: Fastening the AC Power Cord to the Power Supply
Verify that the AC power cord is not touching or blocking access to router components,
15.
and that it does not drape where people could trip on it.
Repeat the procedure for the other three-phase wye AC power supply.
16.
Chapter 13: Providing Power to the T1600 Router
GND into the grounding point labeled
into the input terminal.
L1 L1
L2 into the L2 input terminal.
into the input terminal.
L3 L3
N into the N input terminal
L1 L2 L3 N
GND .
141