T1600-Sib Description - Juniper T1600 Hardware Manual

T1600-SIB Description

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
When the failed SIB is replaced, it becomes the new backup. SIBs are hot-insertable and
hot-removable.
The T1600 router supports these SIBs:
The T1600-SIB is supported in Junos OS Release 8.5 and later.
NOTE: The T1600 is SIB is required for a standalone T1600 router.
The TXP-T1600 SIB is supported Junos OS Release 9.6R2 and later.
NOTE: The TXP-T1600 SIB is required for connection to a TX Matrix Plus
router.
Figure 20 on page 33 shows a T1600-SIB. T1600-SIBs are supported only on standalone
T1600 routers. A T1600 router in a routing matrix does not support T1600-SIBs.
Figure 20: T1600-SIB
Each T1600-SIB consists of the following components:
Switch fabric ASICs.
High-speed links to each FPC.
SIB online/offline button, located on the SIB faceplate.
Three LEDs— ACTIVE , OK
status of the T1600-SIB. The
T1600 Switch Interface Board (SIB) Description on page 32
T1600-SIB LEDs on page 34
Maintaining the T1600 SIBs on page 168
Replacing a T1600-SIB on page 230
Chapter 3: T1600 Router Hardware Components Overview
, and FAIL —located on the SIB faceplate that display the
and LEDs are replicated on the craft interface.
OK FAIL
33