Supplies - Juniper T1600 Hardware Manual

Removing the T1600 Installation Handle and Reinstalling the Power Supplies
Copyright © 2010, Juniper Networks, Inc.
Figure 58: Installing the Router in the Rack
NOTE: This illustration depicts the router being installed in a four-post rack..
After you have installed the router, remove the installation handle and reinstall the two
power supplies in the chassis by following this procedure, starting with the lower power
supply (see Figure 59 on page 100):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the installation handle completely, and remove the
2.
handle from the chassis.
For the DC power supplies, switch the circuit breakers on the power supply faceplate
3.
to the off position ( O ). For the AC power supplies, switch the power switch on the
power supply to the standby position.
Using both hands, slide the power supply into the chassis until you feel resistance.
4.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
5.
until they stop.
Chapter 9: Installing the T1600 Router Using a Mechanical Lift
99