Juniper T1600 Hardware Manual page 223

Copyright © 2010, Juniper Networks, Inc.
The terminal blocks that plug into the alarm relay contacts are supplied with the router.
They accept wire of any gauge between 28 AWG and 14 AWG (0.08 and 2.08 mm
which is not provided. Use the gauge of wire appropriate for the external device you are
connecting.
To replace the wires connecting to an alarm-reporting device:
Disconnect the existing wire at the external device.
1.
Prepare the required length of replacement wire with gauge between 28 AWG and 14
2.
AWG (0.08 and 2.08 mm
Using a 2.5-mm flat-blade screwdriver, loosen the small screws on the face of the
3.
terminal block and remove the block from the relay contact.
Using the 2.5-mm flat-blade screwdriver, loosen the small screws on the side of the
4.
terminal block. Remove existing wires from the slots in the front of the block and insert
replacement wires. Tighten the screws to secure the wire.
Chapter 17: Replacing T1600 Router Hardware Components
2
).
2
),
199