Powering On The Dc-Powered T1600 Router - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
Related
Documentation

Powering On the DC-Powered T1600 Router

136
Figure 87: Connecting Power to the Four-Input 240-A DC Power Supply
Cable lug
Locking
washer
Nut
Connecting a Replacement T1600 Three-Input 240-A Power Supply on page 267
T1600 Preventing Electrostatic Discharge Damage on page 312
T1600 General Electrical Safety Guidelines on page 330
T1600 DC Power Cables and Lugs on page 354
You can use this procedure for a T1600 router for either three-input 240-A DC power
supplies or four-input 240-A DC power supplies.
To power on the DC-powered router:
Verify that the power supplies are fully inserted in the chassis and that the captive
1.
screws on their faceplates are tightened.
Verify that the source power cables are connected to the appropriate terminal: the
2.
positive (+) source cable to the return terminal (labeled
source cable to the input terminal (labeled
Verify that an external management device is connected to one of the Routing Engine
3.
ports on the CIP ( AUXILIARY
Terminal studs
).
–48V
, CONSOLE , or ETHERNET
) and the negative (–)
RTN
).
Copyright © 2010, Juniper Networks, Inc.