Verifying The Installation Of A Txp-T1600 Sib - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Verifying the Installation of a TXP-T1600 SIB

236
Figure 135: Installing a TXP-T1600 SIB
To verify that the TXP-T1600 is functioning normally:
Check the LEDs on the TXP-T1600 faceplate. A few minutes after the TXP-T1600 is
1.
installed:
The green OK LED should light steadily, indicating that the TXP-T1600 SIB is installed
correctly.
The green port LED should light steadily, indicating that the link between the
LINK
TXP-F13 SIB port and the TXP-T1600 SIB port has been established successfully.
The green port LED should light steadily, indicating that full optical power
RxPWR
is being received.
The green OK LED should light steadily a few minutes after the TXP-T1600 is
installed.
If the LED is lit steadily, remove and install the TXP-T1600 again. Make sure
FAIL
that the TXP-T1600 is seated properly. If the
TXP-T1600 is not functioning properly. Contact your customer support
representative.
Verify that four TXP-T1600s are in the
2.
Display the status of the TXP-T1600 by issuing the
user@host> show chassis sibs
LED still lights steadily, the
FAIL
state and one SIB is in the
Online
show chassis sibs
Copyright © 2010, Juniper Networks, Inc.
state.
Spare
command: