Storing T1600 Fpcs - Juniper T1600 Hardware Manual

Related
Documentation

Storing T1600 FPCs

Copyright © 2010, Juniper Networks, Inc.
Figure 100: Holding an FPC Horizontally
T1600 Flexible PIC Concentrator (FPC) Description on page 18
Replacing a T1600 FPC on page 237
Storing T1600 FPCs on page 165
When an FPC is not installed in a router, the FPC must be either stored in the container
in which a spare FPC is shipped or stored horizontally with the component-side up on a
flat, stable surface. When you store an FPC on a horizontal surface or in the shipping
container, always place it inside an antistatic bag. Because the FPC is heavy and because
antistatic bags are fragile, inserting the FPC into the bag is easier with two people. The
storage procedures are as follows:
When storing an FPC with two people, one person holds the FPC in the horizontal
position with the faceplate facing their body, the other person slides the opening of
the bag over the FPC connector edge.
When storing an FPC with one person, you must insert the FPC into a bag by yourself.
First lay the FPC horizontally on a flat, stable surface, component-side up. Orient the
FPC with the faceplate facing you. Carefully insert the FPC connector edge into the
opening of the bag, and pull the bag toward you to cover the FPC.
CAUTION: To prevent damage when storing FPCs:
Never lay an FPC component-side down.
Chapter 15: Maintaining T1600 Router Hardware Components
165