Replacing T1600 Packet Forwarding Engine Components; Replacing A T1600 Fpc; Removing A T1600 Fpc - Juniper T1600 Hardware Manual

Related
Documentation

Replacing T1600 Packet Forwarding Engine Components

Replacing a T1600 FPC

Copyright © 2010, Juniper Networks, Inc.
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online
To bring a TXP-T1600 online, issue the
command.
TXP-T1600 SIB Description on page 34
TXP-T1600 SIB LEDs on page 35
Cleaning Fiber-Optic Array Components with the Dry Cloth Cleaning Tool on page 157
T1600 Preventing Electrostatic Discharge Damage on page 312
Replacing a T1600 FPC on page 237
Replacing a T1600 PIC on page 245
Replacing a T1600 PIC Cable on page 249
Replacing a T1600 Transceiver on page 252
The FPCs are hot-insertable and hot-removable. When you remove an FPC, the router
continues to function, although the PIC interfaces installed on the FPC being removed
no longer function.
Removing a T1600 FPC on page 237
Installing a T1600 FPC on page 240

Removing a T1600 FPC

The router holds up to eight FPCs, which are installed vertically in the front of the router.
An empty FPC weighs approximately 25 lb (11.3 kg) and an FPC with PICs installed can
weigh up to 37 lb (14.5 kg).
Each FPC slot not occupied by an FPC must be covered by an FPC blank panel. An FPC
blank panel weighs 7 lb (3 kg).
To remove an FPC (see Figure 136 on page 240):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Before removing an FPC, record its location in the chassis so that you can reinstall
3.
each FPC in the correct slot.
Use one of the following methods to take the FPC offline:
4.
Chapter 17: Replacing T1600 Router Hardware Components
Uptime
0 days, 30 minutes, 12 seconds
0 days, 25 minutes, 45 seconds
0 days, 20 minutes, 28 seconds
0 days, 15 minutes, 7 seconds
0 days, 10 minutes, 52 seconds
request chassis sib online
operational mode
237