Removing The T1600 Sibs - Juniper T1600 Hardware Manual

Removing the T1600 SIBs

Copyright © 2010, Juniper Networks, Inc.
Figure 63: Removing a Three-Phase Delta AC Power Supply Before
Installing the Router
Figure 64: Removing a Three-Phase Wye AC Power Supply Before
Installing the Router
Five SIBs are installed in the router. The SIBs are located in the rear of the chassis in the
slots marked through
SIB0
Each TXP-T1600 SIB weighs approximately 10.2 lb (4.6 kg).
To remove the SIBs (see Figure 65 on page 106):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
3.
handles on each side of the SIB faceplate.
Flip the ejector handles outward to unseat the SIB.
4.
Chapter 10: Installing the T1600 Router Without a Mechanical Lift
. Each T1600-SIB weighs approximately 6.5 lb (3 kg).
SIB4
105