Installing A T1600 Dimm Module; Replacing A T1600 Routing Engine - Juniper T1600 Hardware Manual

Replacing a T1600 Routing Engine

Copyright © 2010, Juniper Networks, Inc.
Place the DIMM module on the antistatic mat or in the electrostatic bag.
6.
Push the plastic ejectors to close the empty DIMM module slot.
7.

Installing a T1600 DIMM Module

To insert a DIMM module into the Routing Engine:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the DIMM module from its electrostatic bag.
2.
To open the empty DIMM slot, press the plastic ejectors open.
3.
Grasp the DIMM module by the edges, being careful not to touch any electrical
4.
components.
Pressing firmly on both ends, push the module into the slot until the ejectors return
5.
completely to the closed position.
Install the Routing Engine.
6.
You can view the the SDRAM configuration and verify the DIMM was installed correctly
7.
by issuing the show chassis routing-engine
Figure 122: Installing the DIMM Module
Removing a T1600 Routing Engine on page 222
Installing the T1600 Routing Engine on page 224
Verifying the Installation of the T1600 Routing Engine on page 225
Chapter 17: Replacing T1600 Router Hardware Components
command.
221