Juniper T1600 Hardware Manual page 316

Hide thumbs Also See for T1600:

Table of Contents

T1600 Core Router Hardware Guide

NOTE: After powering off a power supply, wait at least 60 seconds before

turning it back on.

Remove the ESD grounding strap from the ESD point on the chassis, and attach it to

an approved site ESD grounding point. See the instructions for your site.

Disconnect the AC power cord (see Figure 173 on page 292) from the power source.

Figure 173: Three-Phase Wye AC Power Supply

Remove the ESD grounding strap from the approved site ESD grounding point. See

the instructions for your site. Reconnect the strap to one of the ESD points on the

Using a number 2 Phillips (+) screwdriver, unscrew the two screws on the metal cover

protecting the AC terminal block.

Chapters

Table of Contents