Installing A T1600 Lcc-Cb - Juniper T1600 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
Figure 120: Removing an LCC-CB

Installing a T1600 LCC-CB

To install an LCC-CB (see Figure 121 on page 220):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the LCC-CB with the guides inside the chassis.
2.
Slide the LCC-CB into the chassis, carefully ensuring that it is correctly aligned.
3.
Grasp both ejector handles, and press them inward to seat the LCC-CB.
4.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
5.
number 2.
If applicable, reconnect the cable previously plugged into the CIP port.
6.
If power is applied to the Routing Engine and its corresponding LCC-CB is functioning
7.
normally, the LCC-CB comes online automatically. To verify that the LCC-CB is
functioning normally, check the LEDs on its faceplate. The green
steadily a few minutes after the LCC-CB is installed. If the
remove and install the LCC-CB again. If the
is not functioning properly. Contact your customer support representative.
To check the status of the LCC-CB, use the CLI command:
user@host> show chassis environment cb
Chapter 17: Replacing T1600 Router Hardware Components
FAIL
FAIL LED still lights steadily, the LCC-CB
LED should light
OK
LED is lit steadily,
219