Installing A T1600 Four-Input 240-A Power Supply - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
272
Figure 156: Removing a Four-Input 240-A DC Power Supply
WARNING: Do not touch the power connectors on the rear of the power
supply (see Figure 157 on page 272). They can contain dangerous voltages.
Figure 157: Rear of the Power Supply Showing Midplane Connectors

Installing a T1600 Four-Input 240-A Power Supply

Each four-input 240-A DC power supply weighs approximately 26.6 lb. (12.0 kg). To
install a four-input 240-A DC power supply:
Make sure that the voltage across the DC power source cable leads is 0 V and that
1.
there is no chance that the cables might become active during installation.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on the power supply faceplate to the
3.
position (
OFF
Copyright © 2010, Juniper Networks, Inc.
).
O