T1600-Sib Leds; Txp-T1600 Sib Description - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

T1600-SIB LEDs

Related
Documentation

TXP-T1600 SIB Description

Related
Documentation
34
Table 5 on page 34 describes the functions of the T1600-SIB LEDs. If all three LEDs are
off, the SIB is not receiving power. The craft interface has three additional LEDs that show
the status of each SIB.
Table 5: T1600–SIB LEDs
Label Color
ACTIVE Green
OK Green
Yellow
FAIL
T1600-SIB Description on page 33
Figure 21 on page 34 shows a TXP-T1600 SIB. A T1600 router in a routing matrix requires
TXP-T1600 SIBs. Each TXP-T1600 SIB weighs 10.2 lb (4.6 kg).
Figure 21: TXP-T1600 SIB
Each TXP-T1600 SIB consists of the following components:
Switch fabric ASICs.
High-speed links to each FPC.
SIB online/offline button, located on the SIB faceplate.
Three LEDs located on the SIB faceplate that display the status of the T1600-SIB. The
and LEDs are replicated on the craft interface.
OK FAIL
T1600 Switch Interface Board (SIB) Description on page 32
TXP-T1600 SIB LEDs on page 35
Maintaining the T1600 SIBs on page 168
Replacing a TXP-T1600 SIB on page 233
State Description
On steadily SIB is in active mode.
On steadily SIB is functioning normally.
Blinking SIB is starting up.
On steadily SIB has failed.
Copyright © 2010, Juniper Networks, Inc.