Replacing A T1600 Three-Phase Wye Ac Power Supply Cord - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide
Related
Documentation

Replacing a T1600 Three-Phase Wye AC Power Supply Cord

296
NOTE: After a power supply is powered on, it can take up to 60 seconds
for status indicators—such as the LEDs on the power supply, the command
output displays, and messages on the LED display on the craft interface—to
indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.
Figure 177: Installing a Three-Phase Wye AC Power Supply
T1600 Three-Phase Delta and Wye AC Power Supply Overview on page 65
T1600 Three-Phase Delta and Wye AC Power Supply LEDs on page 68
Troubleshooting the T1600 Power System on page 185
T1600 Preventing Electrostatic Discharge Damage on page 312
T1600 AC Power Cord Specifications on page 360
The T1600 router has either one nonredundant power supply or two redundant,
load-sharing power supplies. An AC power supply cord on a redundant power supply is
hot-insertable and hot-removable. When a redundant power supply is powered down,
the other power supply automatically assumes the entire electrical load for the router.
If you have only one power supply, you must power off the system before removing the
AC power supply cord.
Removing a T1600 Three-Phase Wye AC Power Supply Cord on page 297
1.
Installing a T1600 Three-Phase Wye AC Power Supply Cord on page 298
2.
Copyright © 2010, Juniper Networks, Inc.