Juniper T1600 Hardware Manual page 302

Hide thumbs Also See for T1600:

Table of Contents

T1600 Core Router Hardware Guide

Attach a negative (–) DC source power cable lug to the

Secure the cable lug to the terminal stud, first with a washer, then with a nut (see

Figure 162 on page 278 and Figure 163 on page 279). Use a 7/16-in. (11-mm) nut driver

to tighten the nut. Apply between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) of torque

to each nut.

CAUTION: You must use an appropriate torque-controlled tool to tighten

the nuts. Applying excessive torque damages the terminal studs and the

power supply. The absolute maximum torque that may be applied to this

nut is 45 in-lb (5.0 Nm).

Figure 162: Connecting a Power Cable to a Three-Input 240-A DC Power

(input) terminals.

Chapters

Table of Contents