Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 387

Copyright © 2010, Juniper Networks, Inc.
—(Optional) Restart the Point-to-Point Protocol (PPP) process.
ppp
—(Optional) Restart the Point-to-Point Protocol over Ethernet (PPPoE) process.
pppoe
protected-system-domain-service
(PSD) process.
redundancy-interface-process
—(Optional) Restart the remote operations process, which provides
remote-operations
the ping and traceroute MIBs.
root-system-domain-service
—(EX Series switch only) (Optional) Restart the routing protocol process.
routing
routing <logical-system logical-system-name>
process, which controls the routing protocols that run on the router or switch and
maintains the routing tables. Optionally, restart the routing protocol process for the
specified logical system only.
—(Optional) Restart the sampling process, which performs packet sampling
sampling
and cflowd export.
scc —(TX Matrix routers only) Restart the software process on the TX Matrix router (or
switch-card chassis).
—(EX Series switch only) (Optional) Restart the secure Neighbor
secure-neighbor-discovery
Discovery Protocol process.
—(TX Matrix Plus routers only) Restart the software process on the TX Matrix
sfc number
Plus router (or switch-fabric chassis). Replace
service-deployment —(Optional) Restart the service deployment service process.
services pgcp gateway gateway-name
BGF running on an MS-PIC. This option does not restart the pgcpd process running
on the Routing Engine. To restart the pgcpd process on the Routing Engine, use the
option.
pgcp-service
—(EX Series switch only) (Optional) Restart the flow sampling (sFlow
sflow-service
technology) process.
—(Optional) Restart the SNMP process, which provides the router's or switch's
snmp
SNMP master agent.
soft —(Optional) Reread and reactivate the configuration without completely restarting
the software processes. For example, BGP peers stay up and the routing table stays
constant. Omitting this option results in a graceful restart of the software process.
—(J Series router only) (Optional) Restart the USB control process.
usb-control
vrrp —(EX Series switch only) (Optional) Restart the Virtual Router Redundancy Protocol
process.
Chapter 17: Operational Commands for System Setup
—(Optional) Restart the Protected System Domain
—(Optional) Restart the ASP redundancy process.
—(Optional) Restart the Root System Domain (RSD) service.
—(Optional) Restart the routing protocol
number
—(Optional) Restart the pgcpd process for a specific
with .
0
283