Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 364

Complete Software Guide for Junos
Additional Information
Required Privilege
Level
List of Sample Output
Output Fields
260
®
OS for EX Series Ethernet Switches, Release 10.4
—(EX Series switches only) (Optional) Halt a partition on the boot media. This
slice slice
option has the following suboptions:
—Halt partition 1.
1
2 —Halt partition 2.
—Reboot from the alternate partition.
alternate
On the M7i router, the request system halt
the Packet Forwarding Engine. The power-down process can take as long as 5 minutes.
On a TX Matrix or TX Matrix Plus router, if you issue the
on the master Routing Engine, all the master Routing Engines connected to the routing
matrix are halted. If you issue this command on the backup Routing Engine, all the backup
Routing Engines connected to the routing matrix are halted. If you issue the
halt both-routing-engines
Routing Engines on the routing matrix are halted.
NOTE: If you have a router or switch with two Routing Engines and you want
to shut the power off to the router or switch or remove a Routing Engine, you
must first halt the backup Routing Engine (if it has been upgraded), then halt
the master Routing Engine. To halt a Routing Engine, issue the
command. You can also halt both Routing Engines at the same time by
halt
issuing the request system halt both-routing-engines
maintenance
request system halt on page 261
request system halt (in 2 Hours) on page 261
request system halt (Immediately) on page 261
request system halt (at 1:20 AM) on page 261
When you enter this command, you are provided feedback on the status of your request.
command does not immediately power down
command on the TX Matrix or TX Matrix Plus router, all the
command
request system halt
request system
request system
command.
Copyright © 2010, Juniper Networks, Inc.