Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1839

Options
Copyright © 2010, Juniper Networks, Inc.
authentication algorithm algorithm-name
the specified BFD session:
meticulous-keyed-md5
authentication key-chain key-chain-name
BFD session using the name of the security keychain. The keychain name must match
one of the keychains configured in the
at the hierarchy level.
[edit security]
authentication loose-check
BFD session. Use only for transitional periods when authentication may not be
configured at both ends of the BFD session.
detection-time threshold milliseconds
detection time adapts to a value equal to or greater than the threshold, a single trap
and a single system log message are sent.
holddown-interval milliseconds
must remain up before a state change notification is sent.
Range: 0 through 255,000
Default: 0
NOTE: You can configure the
minimum-interval milliseconds
routing device transmits hello packets and then expects to receive a reply from a
neighbor with which it has established a BFD session.
Range: 1 through 255,000
minimum-receive-interval milliseconds
the local routing device expects to receive a reply from a neighbor with which it has
established a BFD session.
Range: 1 through 255,000
—Configure the number of hello packets not received by a neighbor
multiplier number
that causes the originating interface to be declared down.
Range: 1 through 255
Default: 3
no-adaptation —Configure BFD sessions not to adapt to changing network conditions.
We recommend that you not disable BFD adaptation unless it is preferable to not
to have BFD adaptation enabled in your network.
transmit-interval threshold milliseconds
transmit interval adapts to a value greater than the threshold, a single trap and a
single system message are sent. The interval threshold must be greater than the
minimum transmit interval.
Chapter 73: Configuration Statements for Layer 3 Protocols
—Configure the algorithm used to authenticate
,
simple-password keyed-md5
, meticulous-keyed-sha-1 .
—Associate a security key with the specified
authentication-key-chains key-chain
—(Optional) Configure loose authentication checking on the
—Configure a threshold. When the BFD session
—Configure an interval specifying how long a BFD session
holddown-interval
—Configure the minimum intervals at which the local
— Configure only the minimum interval at which
—Configure a threshold. When the BFD session
, ,
keyed-sha-1
statement
option only for EBGP peers.
1743