Install The Side Access Panels - Spectra Logic T-Series Spectra T200 User Manual

4. Engage the tabs with the slots in the front of the library, then slide the
5. Proceed to

Install the Side Access Panels

If you accessed the transporter from the side, use the following steps to
reinstall the access panels on the right side of the library.
1. Slide the top edge of the upper access panel into the slots on either side
2. Align the screw holes on the top edge of the upper access panel (circled
3. Position the lower access panel with the notched edge down, aligning
4. Proceed to
December 2008
cover downward. Push the upper edge of the cover toward the front
panel until the magnets secure it to the front panel.
Push inward
Slide downward
Figure 182 Install the filter cover.
Power On the Library on page
the chassis so that the locking tabs on each side of the panel engage top
edge of the chassis.
in Figure 176 on page
Phillips screwdriver to install the screws securing the cover to the
chassis.
Note: The upper access panel can be identified by the lip on its lower
edge. This lip fits under the top edge of the lower access panel.
the holes on the top edge of the panel (circled in Figure 30) with the
corresponding holes in the chassis. Use a #2 Phillips screwdriver to
install the screws securing the cover to the chassis.
Power On the Library on page
Access the Library Interior to Check for Blockages
Tab
270.
264) with the screw holes in the chassis. Use a #2
270.
T200, T380, and T680 Libraries
269