Spectra Logic T-Series Spectra T200 User Manual page 211

Enable Encryption Using Direct-Attach Drives
1. From the Chambers and Drives screen in the partition configuration
2. Select the encryption options you want to use:
3. Navigate through the remaining partition configuration screens by
4. When you reach the Save Partition screen, select Save and proceed as
December 2008
sequence, select Next. The Encryption screen displays.
Note: If the partition can support encryption, the encryption choices
that display and are available depend on the hardware for the
partition.
Figure 130 The Encryption screen (drive-based
encryption).
If you do not need to encrypt data written to the tapes in this
partition, select No Encryption.
To use drive-based encryption, select Drive-based Encryption.
Note: With drive-based encryption, only one key is allowed per LTO-4
tape. To use a new encryption key on a tape previously
encrypted with a different encryption key, you must first recycle
the tape through BlueScale Encryption, as described in
Media on page
selecting Next.
described in Confirm and Save Partition Settings on page
Assigning the Encryption Key to a Partition
221.
T200, T380, and T680 Libraries
Recycling
162.
211