Configuring Network Settings - Spectra Logic T-Series Spectra T200 User Manual

Chapter 8 — Configuring the Library
5. Scroll down until you see the Other Settings pane
6. Enter the camera's IP address in the BlueScale Vision IP Address field.
7. Select Save.

Configuring Network Settings

The library needs to have a unique IP address when it is connected to an
Ethernet network to provide remote management using a standard web
browser. If the network is configured to allow access to the internet, you
can use a web browser to manage the library from any remote location.
By default, the IP address for the Ethernet port on the LCM is set using
Dynamic Host Configuration Protocol (DHCP). If your network does not
use DHCP, or if you simply want the library to have a fixed IP address, you
can configure a static (fixed) IP address as described in this section. Using a
static IP address ensures that you always know the IP address for the
library and is highly recommended.
Use the following steps to modify the library's IP address settings.
1. Select Edit next to Network Settings. The Network Settings screen
2. Select either DHCP or Static (highly recommended) as the addressing
184
User Guide
page 179).
Note:
You can disable access to the camera by setting the IP address to
0.0.0.0.
displays.
Figure 115 The Network Settings screen.
method.
If you select static addressing, enter the following information:
Address – Enter a valid Class A, B, or C IP address in the form
nnn.nnn.nnn.nnn.
Subnet – Enter the subnet mask. The subnet mask must be a valid
octet in the form nnn.nnn.nnn.nnn.
(Figure 111 on
91090000