Spectra Logic T-Series Spectra T200 User Manual page 161

3. If you want to enable Automatic Drive Cleaning in this data partition,
4. If you are not logged into the encryption application or have not
Configure the Drive SCSI ID
The SCSI ID for each drive determines how the drive is addressed on the
SCSI bus.
1. From the Chambers and Drives screen, select Next. The SCSI ID's screen
2. Enter a SCSI ID for each drive.
Make sure that the SCSI IDs you specify are not assigned to other devices on the
Caution
same SCSI bus. Assigning the same SCSI ID to multiple devices on the same SCSI
bus will cause communication problems on the bus.
3. Proceed to
December 2008
use the Cleaning Partition drop-down list (see
select a previously created cleaning partition (see
Cleaning Partition on page
Automatic Drive Cleaning, select None.
Note: The option to select a cleaning partition is only available if you
entered an Automatic Drive Cleaning license key and
configured a cleaning partition.
configured encryption, proceed to
can configure the partition to use encryption later, as described in
Configuring Encryption on page
If you logged into the encryption application (see
already configured encryption, the Encryption screen displays.
See Enable Encryption Using Direct-Attach Drives on page 211
information about this screen. After you complete the Encryption
screen, proceed to Configure the Drive SCSI
displays.
Figure 93 The SCSI ID's screen.
Each device on the SCSI bus must have a unique SCSI ID. SCSI IDs can
range from 0 to 15 on a wide SCSI bus.
Configure User
Creating a New Data Partition
Figure 76 on page
164). If you do not want to enable
Configure the Drive SCSI
204.
ID.
Access.
T200, T380, and T680 Libraries
143) to
Configuring a
ID. You
page 135) and have
for
161