Spectra Logic T-Series Spectra T200 User Manual page 103

Use the following steps to import one or more empty TeraPack magazines
into a partition's entry/exit pool.
1. Before beginning, have on hand one or more empty TeraPack
2. If it is not already displayed, access the Import/Export TeraPack Cases
3. From the Partition drop-down menu, select the partition into which you
4. Select Import (Entry/Exit).
5. Insert an empty magazine into the open TAP, making sure that it is
6. Manually raise the TAP door until it latches closed, moving the
7. Select Continue in the Feedback Required screen. The transporter
8. The TAP door opens again, ready for the next import.
9. Repeat Steps 5 through 7 to load any remaining magazines into the
December 2008
magazines. The maximum number of empty magazines required
corresponds to the number of chambers in the entry/exit pool.
screen from the General toolbar (see
Storage Pool on page
want to import the empty magazines, then select Go.
The TAP opens and a Feedback Required screen displays on the user
interface.
oriented correctly (see
The alignment guides on each side of the magazine (see
page 39) slide easily into the grooves on either side of the TAP opening.
If the magazine does not slide into place easily, remove it and reinsert it.
magazine into the TAP.
Note: Close the TAP door firmly, but do not use force to close it.
retrieves the magazine from the TAP and moves it to the entry/exit
pool.
entry/exit pool, selecting Continue each time.
The import process continues automatically as long as there are empty
entry/exit pool chambers to fill. When there are no empty chambers
remaining, the process stops automatically and the LC redisplays the
Import/Export TeraPack Cases screen.
If you want to import fewer magazines than there are entry/exit
chambers, select Stop Importing after you insert the last magazine into
the TAP.
Importing Media and Cleaning Cartridges
Step 2
100).
Figure 45 on page 96).
T200, T380, and T680 Libraries
of Importing Media into the
Figure 15 on
103